C&C Cases manufacture the following case styles: EXTRUDED CASES™ make for a sleek design. Constructed from set height aluminium extrusions, both lid and base sections have an integral tongue and groove profile to keep them closed firm and weather resistant. LITE 6 CASES™ are are based on our traditional plywood 6 Panel Case™  design but built using a tri-laminate 10mm thick polypropylene panel. To minimise stress on the tongue and groove case openings we use a valance spanning catch instead of a small recessed catch. 6 PANEL CASES™ are a custom height case body with a set height lid. This style of case can be especially practical if two lids are required. When fitted with recessed hardware they are a strong alternative to our more traditional and heaviest duty 10 Panel Case™. 10 PANEL CASES™ provide you with the highest level of strength and durability. They are built to carry heavy loads for extended periods of time through a variety of hard travelling environments. These cases are typically fitted with large recessed hardware and heavy duty castors. Hardware, an essential part of any good case diet. We use large offset BRACES to make sure that both our mitre cut Tongue&Groove profile and the adjoining corner section is well fastened and stays tight. From small surface mount CATCHES to large recessed keylockable catches we have a range of catches to suit the three case styles we build. What more can we say. CORNERS are an essential element to any case and their ability to withstand varying levels of impact during transit. Large cases are usually better manoeuvred with the addition of CASTORS. View examples and the methods we use when fixing them to our cases. No argument here. Our cases wouldn't be as easy to carry without the aid of HANDLES. Five handle styles on display for you to view. If you want to open your case without having the lid falling off then you need HINGES (unless you want removable hinges). Plenty of examples here.