|We're all for building a quality amplifier case right here in Australia using the finest ingredients at a value for money price.|
|The amp head
case as shown above is our standard top lid hinged case. It's what we've
built forever and it's proven to be the strongest and most straightforward
version possible. No separate lid and base to lose and lighter than a front
and rear lid "rockstar" version (MTV has a lot to answer for).
Fitted as standard with the very best ABS laminated plywood and case hardware from Penn Elcom, the best in locally milled extrusions and of course the high quality Dunlop foams.
Average price: $420 - $450 inc. GST per case plus freight.
|No less than
three different foam types (all a minimum of 25mm thick) ensure your amp
will be riding as safely as possible.
To ensure the best roll possible Penn Elcom castors are used as standard (80mm / small cases and 100mm / larger cases) and bolted to full area plywood wheelboards.
The quality is about as good as it gets.
Average price: $550 - $680 inc. GST per case plus freight.
|The amp case
as shown above was custom made to fit a Fender Deluxe Reverb. It's our
top hinged lid design and lined with high quality 25mm thick Dunlop polyurethane
Built to beat 32kg (amp and case) we were unable to add castors to this case.
That's where trolleys come in handy folks.
|MADE TO ORDER|
quality made to order cases fit correctly. To ensure this we need your
carefully measured dimensions as per the following written procedure and
in relation to the image below it:
WIDTH includes any corners sticking out.
DEPTH includes any corners and is to be measured down at the bottom of the amp if it is slanted (i.e. Fender Twin).
HEIGHT includes underneath feet if any and the top handle if any.
You measure twice and we'll cut once.
03 9723 9184
5 - 7 days
a week by appointment.
17 968 072 039.